Opiniones de los 17 mejores Accesorios De Escopetas Mossberg 590.

Opinión de un comprador: Genial para la escopeta de la 12 corredera

VER MÁS OPINIONES

Opinión de un comprador: After having read the lower-score reviews on this product, I was skeptical but placed an order for one anyway. Then I took it to the range as part of a shotgun-only vest setup I was working on. This setup included this system, shells-through-molle, California CompWorks shell caddies, and fold-open "shot cards" with elastic retention. I put about doscientos cincuenta rounds through my shotgun today across all the systems.
Out of all the retention methods I tested, it blew everything else out of the water. Even working with heavy Mechanix gloves, this device made it easy to grab my shells every time. The spring-loaded design meant that I was always reaching to the exact same place to grab the next shell, unlike the gravity-retention CCW caddies which required me to reach lower and lower, fighting their heavy squeeze-retention method the whole time (they are also open-front, running the risk of shells spinning and falling out of the large open port).
The inherent risk that comes with loop-retention setups of knocking out cuantioso shells if you sweep your arm the wrong way or take a fall was also absent (a risk of both the molle method and the shot cards, especially with the latter having elastic bands for retention which can stretch over time).
I also found it advantageous that you are pulling the shells out the front and away from your body, which means that you regalo't have to fight a loose vest that might just follow the direction of pull upward with other systems.
As for difficulties loading the system mentioned by other usuarios, its tolerances are quite tight. However, not only was I able to cargar it to diez rounds facing the same way with it only getting tight at about the last two, I consider this a non-factor in its use under stress: Load it up with patience BEFORE a clock starts ticking or rounds start flying, and enjoy the extremely good retention and minimal noise on the move that results from these tight tolerances. If you buy it and find the tolerances to be annoying, just load and unload it repeatedly and then try using it "sexy"; most products designed for hard use will have a break-in period. And be careful not to blame a tight system for your own fingers' weakness.
In calzoncillo, it does what it advertises, and does it very well. I will definitely be buying more very soon.

VER MÁS OPINIONES

Opinión de un comprador: Encaja perfecto a mi escopeta, Mossberg 930.
La única queja es que trae 6 tornillos de 1/8 de largo, y deberián de poner 2 de ellos de 1/16.
La solución es cortarlos, para que no bloqueen el cierre.

VER MÁS OPINIONES

Opinión de un comprador: Installation wasn't the easiest. One of the pins did not want to go in for some reason. Took me cuantioso tries and, what felt like, a lot more force than I should be using to get the pins in. After installing, I have taken the shotgun out to the range maybe twice. I noticed after that, one of the nuts was a little loose.
Speaking of nuts, the también does not come with an adapter to tighten said nut so you better hope you have something that fits it. I regalo't know the measurement for this nut, I just ran around the house until I found something that fit (which in my case was a screwdriver with the bit taken out).
The shell holder portion of this carrier is very tight. It takes a bit of time to take out a shell. Let's say it takes 5-7 seconds of fiddling with a shell in the carrier to take it out. I took some sand paper and vigorously tried to loosen the holes. Now it takes about 3-4 seconds to take out a shell with how tight it is. It's still tighter than I would like, but I regalo't feel like sanding down anymore.
Looks great though. It also hides the serie number on mine which is either a interés or a con to different people.

VER MÁS OPINIONES

Opinión de un comprador: Arrivate in avance sono perfette per il mossberg 500 ma io le ho montate su un maverick ochenta y ocho (che è di fatto identico) senza nessun dificultad. La maglietta anteriore si avvita senza sforzo nel buco predisposto nel tappo serbatoio e stringendo anche senza frena filetti e stabile e orizzontale, per quella posteriore va praticato un pre foro nel calcio più piccolo del diametro della vite perché la vite non è fatta per bucare ma sola per autofilettare ma una volta avvitata de la tutto è molto stabile.

VER MÁS OPINIONES

Opinión de un comprador: Holds target load and 1oz slugs very well so far. Only used once but great so far. Only enfriamiento is that as a left hand shooter, it does somewhat dig into your hand but its only painful when firing slugs. Installed on a quinientos noventa mariner. Another issue is that the bolt that replaces the pin leaves a bolt head sticking out about 3mm, its smooth but not flush like the original pin, causing more discomfort when firing as a righty. Last enfriamiento is that the front nut that holds the part on is extremely hard to tighten unless you have a low profile socket because the cutout it fits in is super small. Overall i would recommend it because it does what its supposed to and looks good but i think they couldve designed it better to accomodate leftys as well as designed the front mount nut and bolt much better. Overall good build quality.

VER MÁS OPINIONES

Opinión de un comprador: Aunque su propio importe no es alto, me esperaba algo más. Al abrirla me trate excelente marca, se ve bien a la vista y al tacto. La idea la está trayendo separadamente, se instala fácilmente con unos tornillos. El problema llega al apreciar ajustar la finalidad, por mucho más que muevas los tornillos (lado y mayor) no hace casi nada, no sé si es problema de la mía o es problema de éste modelo en sí mismo. En cuanto al resto, prensa bien y te hace llevar un gran ratito "si logras acertar"

VER MÁS OPINIONES

Opinión de un comprador: Sorprendentemente es un juguete de una calidad excepcional, se le ha regalado a un niño de 5 años le ha provocado golpes la he caído ha jugado le ha hecho de todo y continúa todo sano y excepto como el primero de los días.
Bastante fácil de usar para un niño, no dispara nada pero hace el ruido y está trayendo unos cartuchos para descubrir la escopeta cargarla y regresar a abrirla en qué momento es disparado.

VER MÁS OPINIONES

Opinión de un comprador: Merecido lo que estaba buscando! !Muy buen material y se están viendo buenas costuras! La puse en un Franchi SPS trescientos cincuenta y queda de gran lujo! !6 cartuchos del 12 que son simples de cargar y retirar. La volvería a adquirir sin lugar a dudas.

VER MÁS OPINIONES

Opinión de un comprador: Es muy injusto no sirve ,,se mueve por el carril ,,producto malisimo

VER MÁS OPINIONES

Opinión de un comprador: It's a little smaller than I expected but in my situation that's a good thing. My shotgun is a 14" barrel as a frame of reference. Personally I wanted something that had the grip accessible so this is perfect. Had to play with it a bit to make a holding strap around the pistol grip, but there's enough straps that come with it to suit your purpose. Over all it seems cheaply made and I regalo't expect it to hold up through an apocalypse, but it would get you through the first wave. It's also only $treinta though so what's to complain about?

VER MÁS OPINIONES

Opinión de un comprador: The screws provided were too short to go through the body of the shotgun and the holder as it's designed. The plate threaded holes were off slightly and could not be moved/filed over or else you would need to rethread the holes which wouldn't be able to do with an oblonged hole.

VER MÁS OPINIONES

Opinión de un comprador: Genial todo bien lo q se esperaba

VER MÁS OPINIONES

Opinión de un comprador: Me llegó defectuoso sin las anillas

VER MÁS OPINIONES